The basic principle of KOYO imported bearing storage and lubrication replacement

2019-5-20 10:23:54

KOYO bearing oil inspection and refueling alternatives, taking out a small amount of oil, fresh oil samples and comparative capacity units, can be used for oil testing to ensure qualified oil. If the sample appears turbid and then mixed with water, the result is that we often say that the emulsified oil, you should KOYO bearing a darker color, if the sample or process thickens, this may indicate that the oil has begun to carbonize completely to replace the old oil. If possible, use fresh oil to wash the oil. Oil change should be ensured to replace the new oil, the same old models, and add oil to meet the requirements.
       KOYO bearings, oil bath lubrication system, if the oil temperature is 60 ° C (140 ° F), the oil is not contaminated, the oil can be replaced once a year. If the oil temperature is 60-100 ° C (140-210 ° F), then change the oil four times a year. If the oil temperature is between 100-120 ° C (210-250 ° F), then change the oil once a month. If the oil temperature is above 120 ° C (250 ° F), then change the oil once a week.
       KOYO bearings are stored in a storage warehouse with no leaks, avoid direct sunlight, indoor air circulation, but no dust. The Ministry of Finance should set up ventilation and temperature control equipment. The warehouse should be kept dry, the relative humidity is below 80%, and the indoor temperature is 25 degrees. The temperature change at night should not be so large. If the temperature is too low, it is easy to crystallize and crack the rust remover, causing some bare metal corrosion, high temperature resistance, rust inhibitor is easy to lose (evaporate) or deteriorate, and the temperature difference between day and night moisture is easily corroded and caused to condense in KOYO bearing. surface. In the winter season, the bearings should not be placed close to the heating. The Ministry of Finance is hard on the ground and it is not easy to get dust from the ground. Bearings are not associated with acids, alkalis, salts and other corrosive materials, chemical raw materials, materials and water in a large storage warehouse. Hazardous gases that are not easily invaded by bearings placed in the warehouse.

Top